The ECS 950 control unit uses several internal cards, including the (standard functions) and the manoeuvring card , which features status LEDs for the stop circuit and limit switches.
: Install the second stop ring and mount the torque bar. A rubber damper must be placed between the torque bar and the console to absorb vibration. crawford cdm9 950 installation manual
: If major repairs are needed for the electro-motor, sliding clutch, or main relays, official documentation often recommends replacing the complete operator to meet modern safety standards. The ECS 950 control unit uses several internal
: Disengage the door and position it approximately 1.5 meters above the floor before engaging the operator again. : If major repairs are needed for the
: Standard CDM9 supports doors up to 400 kg; the HD version handles up to 800 kg. Supply Voltage : 230V AC, single phase, 50/60Hz. Operating Temperature : -20°C to +55°C. Mechanical Installation Steps
Use the "Hold-to-run" command (pressing the Up/Down buttons) to bring the rubber sealing edge to the 1m mark.