Gpsuinet Setup ~repack~ Access

Check if the USB driver is properly installed in Windows Device Manager, specifically under Ports (COM & LPT).

Ensure no other application (like a serial monitor or another instance of u-center) is using the COM port.

Always verify and update the receiver firmware to the latest version. Summary Checklist Key Setting 1 Connect via USB Select correct COM Port 2 Set Baud Rate 115200 or 9600 3 Configure Rate 100ms (10Hz) 4 Enable RTCM RTCM 3.2 (Base) 5 Save (CFG) Flash + RAM gpsuinet setup

Ensure data is flowing (green blinking in the bottom right corner). 3. Configuring GNSS Receiver Settings (GPSUINET)

By following these steps, you can ensure your GNSS system is correctly configured for high-accuracy applications. Check if the USB driver is properly installed

What is the specific (e.g., u-blox F9P)? Are you trying to connect to a 3rd-party RTK network ? Configure GPS with U-Center

Once connected, you must configure the receiver to function as a Base or Rover. A. Setting Up as a Rover (10Hz Example) Go to Tools -> Receiver Configuration . Summary Checklist Key Setting 1 Connect via USB

Settings in u-center are temporary by default and will be lost when the device powers off. Go to -> Configuration View -> CFG (Configuration). Select "Save current configuration" .

Click on the Receiver menu -> Connection and select the appropriate COM port .