Use separate cable paths for control wires and power lines to prevent signal interference. Ensure the mains cable enters the housing from the bottom . Initial Programming:
Set the by navigating to menu "01" and holding the "Up" button until the desired position is reached, then press Enter. hormann a445 manual
The control housing must be installed so the door is visible during operation but protected from extreme temperatures. Use separate cable paths for control wires and
The A445 acts as the "brain" of the sectional door, managing power distribution and safety signals. 400V AC / 3-phase / N / PE. The control housing must be installed so the
Integrated SKS (Closing Edge Safety Device) and photocell connections. Operating Temp: -20°C to +60°C . Installation and Commissioning
2-digit 7-segment display for status and error codes.
Only qualified electricians should perform the electrical setup to avoid life-threatening hazards.