Connect the drive to your computer using your chosen cable.
Update procedure. Strap the BOOT0 signal as shown on the above picture. Connect the Gotek to your PC with the USB A USB A cable. ( HxC bootloader installation - HxC2001
The primary purpose of hxc-fw-installer.hex is to prepare a "blank" or factory-stock Gotek drive for the HxC ecosystem. Once this .hex file is flashed onto the drive's internal memory, it installs a specialized bootloader that enables future firmware updates to be performed simply by using a USB stick, eliminating the need for further hardware-level programming. Prerequisites for Installation Hxc-fw-installer.hex
For many drives, you must place a jumper on the BOOT0 pins to put the device into programming mode.
Tools like STM32 Dfuse or the Artery ISP Programmer are required to upload the .hex file from a PC to the drive. Flashing Procedure The installation process generally follows these steps: Connect the drive to your computer using your chosen cable
An STM32 or Artery AT32-based Gotek drive or clone.
Open your programming utility (e.g., Artery ISP Programmer) and select the correct port (often USB DFU ). Connect the Gotek to your PC with the USB A USB A cable
Depending on the drive model, you may need a USB-A to USB-A cable or a USB-to-Serial (TTL) adapter .
Once the .hex file is flashed, the drive is ready to receive the final HxC firmware ( .upd file) via a standard USB stick. Key Benefits of HxC Firmware