Liz Ocean Wsg 32 Install Free Direct

Choose a dry, level surface near the main water inlet. Ensure it is protected from freezing temperatures and direct sunlight.

Slowly turn the water back on. Open the bypass inlet valve only partially to allow the resin tank to fill slowly, preventing air pockets.

Open the lowest faucet in the building to drain remaining water from the pipes. liz ocean wsg 32 install

💡 Check the brine tank monthly and keep it at least one-third full.💡 Sanitize: Use a water softener cleaner once every six months to remove iron and resin buildup.💡 Check Bridge: Occasionally break up any "salt bridges" (hard crusts) that form in the brine tank.

It is highly recommended to install a three-valve bypass manifold. This allows you to service the unit without cutting off water to the entire house. Step 2: Positioning the WSG 32 Choose a dry, level surface near the main water inlet

Inspect every joint. If a leak is found, shut off the water immediately and tighten the fitting. Power Up: Plug the WSG 32 into a dedicated GFI outlet.

Pipe cutter, adjustable wrenches, Teflon tape, and soldering equipment (if using copper pipes). Open the bypass inlet valve only partially to

Ensure the brine tank and resin tank are standing perfectly upright.

Before beginning the installation, ensure you have the necessary tools and have selected an appropriate location.

This guide provides a comprehensive walkthrough for installing the WSG 32 system. Pre-Installation Checklist