Makerbase Mks Dlc V21 Manual Link [updated] May 2026

Check if your $32 setting is correct and ensure the TTL wire is on the correct pin. If you need more specific help, I can guide you through: The exact jumper settings for your specific stepper drivers A step-by-step guide for configuring LaserGRBL How to wire limit switches to prevent crashes

Insert your stepper drivers into the slots for the X, Y, and Z axes. makerbase mks dlc v21 manual link

Connect your DC power supply to the screw terminals. Double-check the polarity (+ and -) marked on the board. Most setups use 12V for lasers and 24V for CNC motors to get better torque. 2. Stepper Drivers Check if your $32 setting is correct and

Once connected via USB (usually at ), you may need to adjust these settings in the console: $100, $101, $102 : Steps per mm for X, Y, and Z. $32=1 : Enable Laser Mode (if using a laser). Double-check the polarity (+ and -) marked on the board