Merlin Gerin Multi 9 Ic 2000 P Manual ((new)) 🎁

Install the photo-electric cell outdoors. It must be positioned away from the lights it controls to avoid "cycling" (turning off because it sees its own light). Wiring the Terminals: Terminals 1 & 2: Connect to the 230V AC power supply.

To prevent the lights from flickering due to temporary shadows, lightning, or car headlights, the IC 2000 P has a built-in time delay. On Delay: Approx. 20 to 80 seconds.

Test for a short circuit in the wiring between terminals 6 and 7. Check the Green LED for power supply. Merlin Gerin Multi 9 Ic 2000 P Manual

Connect the two wires leading to the external photo-electric sensor. There is no polarity to observe for the sensor wires. Programming and Calibration

Use the rotary dial on the front of the unit to set the light level at which the circuit should activate. Install the photo-electric cell outdoors

The IC 2000 P features a user-friendly interface on the front face for fine-tuning your lighting automation.

Proper installation is critical for the sensor to provide accurate readings without interference from artificial light sources. To prevent the lights from flickering due to

Approx. 20 to 80 seconds.The unit must sense a consistent light level for this duration before switching states. 3. LED Indicators Green LED: Indicates that the device is powered on.