Shell And Tube Heat Exchanger Revit Family Work -

Assign two connectors to "Hydronic Supply" and two to "Hydronic Return" (or "Steam" depending on the application).

If you are in the early design phase, building a flexible "Type Catalog" family is better. This allows you to swap between a 2-pass and 4-pass configuration or adjust shell diameters as the load requirements change. 2. Essential Geometry and Nested Components shell and tube heat exchanger revit family work

Model these as separate extrusions. Ensure they have a "Length" parameter so they can adjust based on the shell's size. 3. Setting Up Smart Connectors Assign two connectors to "Hydronic Supply" and two

Set the shell-side and tube-side flows correctly. Use the Link Connectors tool so Revit understands that what goes in one side must come out the other, allowing for accurate pressure drop calculations across the system. shell and tube heat exchanger revit family work