Simrad Rf300 Installation Manual __top__ Online

While it is a two-wire system, always follow the specific wiring diagram in your autopilot computer manual to ensure the frequency signal is correctly interpreted.

The unit connects directly to the rudder feedback terminals on your Simrad Autopilot Computer (such as the AC12 or AC42). simrad rf300 installation manual

Drill and tap the rudder tiller arm (typically using a 4.2 mm drill and 5 mm tap). While it is a two-wire system, always follow

Install the RF300 on a stable platform near the rudder post. The center of the RF300 should ideally be in line with the center of the rudder post to ensure geometric accuracy. Install the RF300 on a stable platform near the rudder post

Connect the transmitter rod to the ball joint on the tiller arm.

Once physically installed, you must configure the autopilot software to recognize the unit. Installation manual