Connect the resistor element between Terminals 8 and 9 , with the third "extra" wire going to Terminal 10 . Control Output:
Ensure the thermocouple type set in the software matches the physical sensor connected to avoid incorrect readings. sinotimer mc101 manual
Sinotimer devices are built to resist dust and moisture, but they should still be housed in a proper enclosure for longevity in harsh environments. Temperature Controller - Sinotimer Connect the resistor element between Terminals 8 and
If using an SSR to control a high-current load, always attach a heat sink to prevent the relay from overheating. Temperature Controller - Sinotimer If using an SSR
For models, use the internal relay contacts to switch your load.
0.3% measurement accuracy with a maximum resolution of 0.1°C for thermocouples and RTDs.
Correct wiring is critical for safe operation. Always disconnect power before making connections. Refer to the specific diagram on your unit's label for the most accurate pinouts.