Thyssenkrupp Levant Stair Lift Installation Manual [upd] Full Guide

Before unboxing, ensure your staircase is compatible with the Levant’s specifications.

Ensure the copper charging strips at the top and bottom of the rail are clean and aligned with the "brushes" on the drive unit.

Screw the brackets into the stair treads. For wood stairs, use the provided wood screws; for concrete, use masonry anchors. Step C: Mounting the Drive Unit thyssenkrupp levant stair lift installation manual full

Slide the internal joint pins into the rail channels and tighten the joining bolts until the rail is a single, rigid piece.

Located at the top and bottom of the rail. Remote Controls: Two wireless units. Installation Kit: Brackets (feet), bolts, and screws. 3. Step-by-Step Installation Process Step A: Assemble the Rail Before unboxing, ensure your staircase is compatible with

on the stairs to check the length. If the rail is too long, it can be cut from the bottom end using a circular saw with a metal-cutting blade.

Plug the transformer into your wall outlet and run the low-voltage wire to the rail’s charging point. 4. Calibration and Testing Once assembled, turn the unit on. For wood stairs, use the provided wood screws;

Place the rail on the steps, ensuring a gap of approximately 5 inches (12 cm) between the rail and the wall. Step B: Secure the Mounting Brackets Attach the feet: Slide the mounting brackets onto the rail.

Immediately bolt the mechanical end stops at both ends of the rail to prevent the lift from over-traveling. Step D: Install the Seat Place the seat assembly onto the drive unit’s post.

The Levant is designed for straight indoor staircases only.