Xerox Fault: Code 043-343 ^hot^

: Inspect the connection between the YMC link solenoid (P/J203) and the Drive PWB (P/J413) for signs of damage or open circuits.

Before attempting technical repairs, perform a full restart to clear temporary software glitches.

In some cases, physical misalignment of the drum components can trigger sensor errors. Xerox Fault Code 043-343

: A discrepancy between the printer's software (register information) and the physical state of the YMC link sensor.

: Damaged, shorted, or open circuits between the sensor/solenoid and the Drive PWB (Printed Wiring Board). : Inspect the connection between the YMC link

Reconnect the power and restart the device to see if the code clears. 2. Reseat Drum Cartridges

Power off the printer using the power button on the control panel. and wait at least two minutes. : A discrepancy between the printer's software (register

If the error persists, technicians often use the to isolate the hardware failure:

Open the front cover and to ensure they are properly locked into place. 3. Advanced Diagnostic (For Technicians)

: Check the YMC link sensor (PL 40.10 Item 12) and its connection to the Drive PWB (P/J407). Professional Assistance Fault Code 043-343: YMC Link Sensor Fail - Xerox Support