Xh-m608 Manual May 2026

The is a versatile DC 6-40V battery charge and discharge controller module designed for real-time voltage monitoring and automated protection . Whether you are managing a solar bank, an electric vehicle battery, or a DIY power station, this manual provides the essential steps for wiring, programming, and operating the device safely. 1. Technical Specifications

Sets the trigger for starting a charge or stopping a discharge.

The XH-M608 acts as an intelligent switch. It does not provide power itself; it controls the connection between a power source (charger) or a load and your battery. Xh-m608 Manual

Relay output (works as a switch for your charger or load). Dimensions: Approximately 66 x 46 x 16mm.

The relay does not function; it only displays the current voltage. The is a versatile DC 6-40V battery charge

For a 12V battery, you might set P1 to 10.8V and P2 to 14.4V to automate the charging cycle. P3: Timer Function Set this to 0 to disable the timer.

Sets the trigger for stopping a charge or starting a discharge. Technical Specifications Sets the trigger for starting a

The relay on the board should be placed "in-line" with one of the wires (typically the positive) of your charger or load.

Understanding the limits of your hardware is critical for preventing electrical failure. DC 6V to 40V. Display & Control Accuracy: 0.1V.

Relay closes when voltage ≤ P1 (lower limit) and opens when voltage ≥ P2 (upper limit).